Lithium extraction from salt lake brines with high magnesium/lithium ratio: a review

Environmental Chemistry Letters - The demand for lithium is growing rapidly with the increase in electric vehicles, batteries and electronic equipments. Lithium can be extracted from brines, yet...     

Study on coupling between mineral resources exploitation and the mining ecological environment in Shanxi Province

Environment, Development and Sustainability - Due to rapid socioeconomic development, seeking the coordination of resources exploitation and the ecological environment has become an objective...     

Sb release characteristics of the solid waste produced in antimony mining smelting process

Sb release characteristics of blast furnace slag, mining waste rock and tailing sand were investigated in static immersion and dynamic leaching test. These three kinds of waste samples were collected from the antimony mine in Lengshuijiang, China, produced in mining smelting process. Effects of solid/liquid ratio, sample size and pH of leaching solution on Sb release characteristics were inspected based on the analysis of scanning electron microscope, pH and EC of leachate. The optimal parameters for Sb leaching of each sample were analyzed. For blast furnace slag and mining waste rock, Sb release contents increased along with the decline of solid/liquid ratio. The maximum accumulative release contents were 42.13, 34.26 mg/kg at the solid/liquid ratio of 1:20. While Sb release content for tailing sand decreased first and then increased with the reduction of solid/liquid ratio. When the solid/liquid ratio was 1:5, the accumulative Sb release content reached the most (24.30 mg/kg). Sb release content of mining waste rock increased with the drop of leaching solution pH, with the highest accumulative release content of 26.01 mg/kg at pH 2.0. Sb release contents of blast furnace slag and tailing sand showed positive correlation with the variation of leaching solution pH. The maximum accumulative release contents of these two samples were 215.91 and 147.83 mg/kg, respectively, when leaching solution pH was 7.0. In summary, Sb release capacity of the three samples in descending order was tailing sand, blast furnace slag and mining waste rock. pH and EC of the leachate in dynamic test varied independently with the initial pH of leaching solution while showing close relationship with mineral hydrolysis in the waste.     

Comparisons of three plant species in accumulating polycyclic aromatic hydrocarbons (PAHs) from the atmosphere: a review

Environmental Science and Pollution Research - Plant leaves play a key role in the accumulation of PAHs, as they are able to capture PAHs from the air. In this paper, the mechanism, including...     

不同好氧预处理方式对餐厨垃圾产甲烷的影响

为了研究不同好氧预处理方式对餐厨垃圾厌氧消化产甲烷的影响,通过建立3个模拟厌氧生物反应器,研究了传统厌氧生物反应器C1、上层好氧预处理-厌氧生物反应器C2和底部好氧预处理-厌氧生物反应器C3 3种不同操作条件下的产甲烷过程.结果表明,挥发性有机酸的累积使C1始终处于产甲烷滞后阶段;而C2、C3的好氧预处理通过加快易水解酸化组分和过量挥发性有机酸的好氧降解,有效缓解了酸性抑制,产甲烷滞后时间明显缩短至10 d内.第32天C2停止上层曝气后,在27 d内甲烷浓度达到了50％以上,同时,产甲烷速率迅速上升,并在第81天可达到峰值773 mL/(kg·d).C3在第11天停止底部曝气后,虽然经过22 d的时间甲烷浓度即上升至50％,但之后产甲烷速率经历回落阶段后再次逐渐上升,在实验结束时仅达到517 mL/(kg·d).上层曝气的好氧预处理方式所需曝气时间相对较长,但其产甲烷启动快,与底部曝气相比,其后期的甲烷化过程更稳定并可达到较高的产甲烷速率.     

新制备生物炭的特性表征及其对石油烃污染土壤的吸附效果

生物炭作为一种绿色环保的功能材料因其在污水处理和污染土壤修复方面具有显著效果而受到极大关注.采用红外光谱、元素分析仪及微孔分析对不同温度(200、300、400、500和600℃)条件下制备的木屑和麦秆生物炭进行特性表征,并采用制备的生物炭净化石油污染土壤,分别考察了污染物性质、生物质原料和热解温度对其净化效果的影响.结果表明,随着热解温度的增高,生物炭芳香化程度增加,极性降低,微孔结构逐渐发育,表面积增大.加入生物炭33 d后,污染土壤中总石油烃及其组分烷烃的浓度比对照略有降低,而PAHs浓度下降显著.随着热解温度升高,2种生物炭对PAHs的吸附强度均逐渐增大,芳香度增高、表面积增大是强吸附的主要原因.2种生物炭在400℃及以下温度制备时对PAHs的吸附强度为:木屑生物炭＞麦秆生物炭;而400℃以上温度制备的生物炭吸附强度则相反,即麦秆生物炭＞木屑生物炭,说明生物炭原料对其吸附强度也具有显著影响.     

不同培养条件下锰过氧化物酶(MnP)的合成及其对甲基橙的降解

高效、大规模、低成本合成木质素降解酶是直接采用其降解难降解有机污染物所必须解决的问题.对锰过氧化物酶(MnP)降解甲基橙和在非灭菌的反应器中连续合成MnP的可行性进行考察.结果表明,在采用2 mmol H2O2和1.5 mmol MnSO4的降解体系中,获最大脱色效果,且100、200和300 U/L的MnP可在8h内将甲基橙分别脱色18％、23％和35％;在非灭菌的反应器水平上实现了固定化培养的P.chrysosporium连续23 d合成MnP,但MnP酶活仅为2～ 23 U/L,难以酶解甲基橙;然而,在摇瓶培养条件下固定化的P.chrysosporium合成的MnP却能达1 152 U/L.因此,直接采用MnP对污染物进行降解以及在非灭菌的反应器中持续合成MnP是可行的,但就在非灭菌条件下如何提高MnP的合成量还有待开展深入的研究.     

基于支持向量回归机的南黄海浒苔分布面积预测模型

绿潮作为一种新型的海洋灾害,已经引起了各个国家的重视.依据2012年南黄海海域浒苔遥感监测分布面积数据,选取了温度、天气状况、风向、风力、浪高5种影响浒苔扩散的气候因子,建立了基于SVR的浒苔分布面积预测模型,并与经典的最近邻点插值模型、线性插值模型、3次样条函数插值模型和分段3次Hermite插值模型进行了回归效果的对比.分析结果表明,基于SVR的浒苔分布面积预测模型能够为浒苔遥感数据的插补提供一种方法,且回归效果优于传统的回归方法,为浒苔的防治提供辅助决策信息.     

Air pollution inequality and health inequality in China: An empirical study

Environmental Science and Pollution Research - China’s residents experience unequal exposure to air pollution in different regions, and the corresponding health consequences have increased...